Design Hardware

After buy the wood and the equipment that need to make hardware of this project. the first things that need to is to design the hardware where want to put the item to look like view at hot spring. below are the picture of designing the hardware.

 

before put the glue. the arrangement need to be done in order to make it look nicely. This hardware is to look like at hot spring because the viewer can easily understand  what this project is all about. 

 

Completed design of the hardware.

Testing Project

 

Today i would like to share result of testing of my project. from the figure there are two component that i need to test which is the heater and the water pump. The testing is to ensure that the heater and the water pump can operate when it receive the signal from computer. This test was successfully done  because the heater and the pump can operate as want i wanted.

Drill and Solder

after etching process the pcb board need to be drill in order to insert the component at the pcb board. after the drilling process then it will continue the soldering process.

soldering all the component at the pcb board. After complete the soldering process the leg of component need to be cut to prevent the short circuit.